Moffitt Air Turnover Unit

Air Turnover Units (ATU) efficiently heats large industrial spaces with a minimal amount of equipment. Does not require hanging, extra support, or duct work.

The system pulls the hot air from the higher elevations back to the floor level where it is the most beneficial. This ensures warm air circulates throughout the building, instead of getting trapped at the ceiling, to maintain more uniform temperatures and ensure worker comfort.

Turnover air helps to prevent air stagnation & stratification. Additional options to provide heating, cooling, ventilation, and filtration are available. The system is designed to maximize efficiency, provide long-lasting, reliable heating, and minimize noise.

Features

• Constant air circulation for rapid recovery
• Quick response to temperatures deviating from a set point.
• Thoroughly distributes air throughout the building.
• Highly efficient fan minimizes electrical consumption.
• Outside air is not required, the unit recirculates internal air.
• Quicker, lower cost installation with base mounted air turnover units. Units only require a few hours to stack & wire.
• Factory wired, piped, and test fired.
• Best turndown ratio, up to 60:1, for power burners.
• All-welded structural iron frame, primed with epoxy rust inhibitor
• Bonderized G90 zinc rich “paint grip” 18-gauge sheet metal
• Industrial urethane alkyd enamel machine gray 3 mm thick casing finish
• Expanded metal inlet/discharge screen
• Double wall insulated
• Two-inch-thick Insulated casing with perforated “sound trap” liner
• High efficiency six-bladed airfoil turbine prop moves air with lowest HP
• Continuously welded stainless-steel four pass drum and tube heat exchanger with 80+% efficiency
• Durable casing and high-efficiency system ensure unsurpassed longevity for air turnover units.
• Assurances & testing; ETL & C-ETL listed.

Options

• Cooling, heating, and filtration packages
• Sealed combustion chamber to allow burner operation in negative pressure or contaminated space
• On/off or full modulation forced draft burner
• Programmable for occupied / unoccupied, and varied day scheduling
• Mix box section includes motorized dampers to provide ventilation
• DDC interface or computer controls